{ " Mix320-D Technical Specifications" : { "A320 Specifications" : { "Audio Output" : "1/4" TRS stereo, headphone or line level", "Stereo Mix Output, Headphone/Line" : { "Tip" : " Audio Left;", "Ring" : " Audio Right;", "Sleeve" : " Ground" }, "A-Net I/O" : [ "1 A-Net In, RJ45 connector;", "Supports Pro16 and Pro16e" ], "D/A Conversion" : "44.1/48kHz, 24-bit", "Stereo Operation" : [ "Stereo Link, per channel pair;", "Set at the input module;", "Variable pan per mono channel or pan/spread per stereo channel pair " ], "Headphone Output" : "275 mW per side into 50 Ohms (both sides driven)", "Output Impedance" : "5 Ohms", "Freq. Response" : "3Hz-22kHz +0.2dB/-3dB at 50 Ohms", "THD +N" : "< 0.003%", "Output Voltage for Personal Mixers" : "Transmitted over the Cat-5e cable", "Signal to Noise (unweighted)" : "-106dB (measured with zero data into all channels)", "Latency" : "0.880 msec (measured from analog input to analog output)", "Pro16e A-Net" : [ "Use Cat-5e (or better) cable;", "Maximum 400 ft (122 m) between devices;", "Supports Power Over A-Net" ], "Cat-5 cable" : "Use shielded Cat-5e (or better) cable to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits.", "Power" : "Power is supplied over the Cat-5 cable when connected to an Aviom A-Net Distributor", "Dimensions" : "10.26" (260.6 mm) wide x 6.14" (155.95 mm) deep x 1.91" (48.51 mm) high", "Weight" : "1.3 lb. (0.59 kg)", "Options" : "MT-1a Mic Stand Mount" } }, "D400-Dante Specifications" : { "Dante Interface" : "32 channels (44.1/48kHz Sample Rate)", "Dante Primary I/O" : "RJ45 connector", "Dante Secondary I/O" : "RJ45 connector", "Dante LEDs" : "1GB Network Connection Active (yellow)", "A-Net Out to Personal Mixers" : "Eight RJ45 connectors, powered", "A-Net Out" : "RJ45 connector, unpowered", "LEDs" : "Power On (red); Network Sync (green)", "Stereo Link" : "Two 8-position DIP switch blocks (1-16, 17-32)", "Output Voltage for Personal Mixers" : "Transmitted over the Cat-5e cable", "A-Net Cables" : "Unshielded Cat-5e cable may be used on all rear panel connections", "Power Supply" : "Internal, IEC connector", "Input Voltage" : "100-120 VAC or 200-240 VAC (with selector switch); 50-60Hz @220 W max", "AC Fuse Types" : "230V range: T1.25AL/250V", "Dimensions" : "19" (482.6 mm) wide x 7.386" (187.6 mm) deep; 2U, 3.5" (88.9 mm) high", "Weight" : "12.0 lbs (5.44 kg)" } } |